Windows 7 Netzlaufwerke werden nicht verbunden - TEST

Go to HKEY_LOCAL_MACHINESOFTWAREMicrosoftWindowsCurrentVersionPoliciesSystem and add a DWORD 32-bit key for EnableLinkedConnections and set its value to 1.

You’ll need to reboot afterwards, obviously.

--------------------------------------------------------

Method 1:
Disable the firewall/ anti-virus temporarily installed on your computer and then check if the issue still persists. If the issue resolves, then you might need to uninstall the software and reinstall it back or change the settings and check.

Methods 2:
Make sure these services are set to automatic.
i. Click start and type services.msc in the search box
ii. Check if the following services are started, if not start the service and set it to automatic. List of services:
i. SSDP Discovery
ii. TCP/IP NetBIOS Helper
iii. Computer Browser
iv. Server

Steps to set the services to automatic
i. Search for the service
ii. Right click on the service
iii. If the service is stopped then Start the service
iv. Select Properties
v. And in the Start-up type select Automatic

Method 3:
You may even try the steps listed below in the link:
Troubleshoot problems with computers not appearing on the network map (Holds good for Windows 7)
http://windows.microsoft.com/en-US/windo...the-network-map

You may even refer the below link:
http://windows.microsoft.com/en-us/windo...ection-problems

Similar error code was also discussed in the thread below:
http://social.answers.microsoft.com/Foru...00-98df657fe45c

----------------------------------------------------

To configure the EnableLinkedConnections registry value, follow these steps:

1. Click Start , type regedit in the Start Search box, and then press ENTER.
2. Locate and then right-click the following registry subkey:
HKEY_LOCAL_MACHINESOFTWAREMicrosoftWindowsCurrentVersionPoliciesSystem
3. Point to New , and then click DWORD Value .
4. Type EnableLinkedConnections , and then press ENTER.
5. Right-click EnableLinkedConnections , and then click Modify .
6. In the Value data box, type 1 , and then click OK .
7. Exit Registry Editor, and then restart the computer.


--------------------------------------------------------------------------

1. Goto Control Panel -> All control Panel Items -> Credentials Manager
2. Next to the heading "Windows Credentials" click on the link "Add a Windows credential".
3. Enter the name of your server and the appropriate credentials.
4. Reboot and enjoy
I've noticed that logging in takes few seconds longer, but I think it isn't annoying.


---------------------------------------------------------------------------

run regedit.exe

* Warning do not edit your registry if you don't know what it is *

HKEY_LOCAL_MACHINESYSTEMCurrentControlSetControlNetworkProvider
Set or create a DWORD
RestoreConnection = 0

restart and voila! Problem solved, the mapped drives will not connect untill you access them for the first time.